Simply lay the drainage channel on pea gravel in a trough formed in the basement floor.
Waterguard drainage channel system.
Extra wide to allow footing slab separation which will help reduce cracks in basement floors.
As water is collected in the waterguard drain it will work it s way down to the sump pump pit to be properly discarded.
Creates thermal break between footing and basement floors.
The drainage channel is hidden beneath a layer of concrete.
The system drains into a sump pump or other exterior drain keeping the basement dry.
Water enters the system through channel holes.
Wykamol waterguard has a flange up stand and is fitted around the perimeter of the floor at the vulnerable wall to floor junctions directing any ingress of water towards a sump chamber or drain.
The waterguard drain outlet is an essential accessory to a typical waterguard installation.
Hydro channel plus wall and footing drain board interior installation catches water from wall and footing joint.
Waterguard aqua channel is an engineered basement drainage channel system.
A much better solution than seeping onto your basement.
This channel collects water from the wall floor joint and directs it to the sump chamber.
It sits above the footer and so will not block with dirt and silt like a drain tile system can.
The channel has profiled flanges to permit drainage from basement wall leaks and has holes in the back to collect incoming water allowing the system to manage its exit.
This allows groundwater to enter the drain channel.
Basement waterproofing system advantages.
The wykamol waterguard drainage channel is a pvc drainage conduit for the control of water ingress in below ground waterproofing situations.
Waterguard channel for basement waterproofing.
Plus waterguard comes with a 20 year warranty against clogs.
The entire waterguard system must be connected to your sump pump pit.
The waterguard sub floor drainage system has a patented profile that includes.
Only the top edge of the wall flange is visible so you ll hardly know it s there.
The waterguard system uses drain pipes installed around the perimeter of the basement which is then covered with concrete.
The base of the drytrak drainage channel is sealed to the basement slab floor with a special epoxy adhesive.